Go Back   The Supercar Registry > General Discussion > Pit Area - Racing


Reply
 
Thread Tools Display Modes
  #1  
Old 09-05-2005, 03:59 PM
mrtimstik mrtimstik is offline
Senior Member
 
Join Date: Apr 2005
Location: Chi-town west burbs
Posts: 211
Thanks: 0
Thanked 3 Times in 1 Post
Default Proportioning valve/Roll Control

I have a few questions about the braking system on my car at the track. What is the correct reason for having a brake proportioning valve on the car? At the track, do I(Number 1)crank the rears closed(no fluid pressure to these), do my smoky burn-out and then my run? This concerns me because I will only have front brakes at the end of the track when I believe stopping is far more important then going. Or, do I(Number 2) adjust this valve to allow the front disc brakes to have slightly more grab than the backs(a how-to needed here) and use a button activated, "Roll Control" to lock my fronts for the burn-out and maybe launch? I am confused and welcome any comment that will help me have fun with my car. Thank you very much folks. Tom
__________________
1966 SS Chevy II mean and nasty
Reply With Quote
Click here to view all the pictures posted in this thread...
  #2  
Old 09-05-2005, 07:55 PM
Seattle Sam Seattle Sam is offline
Senior Member
 
Join Date: Apr 2002
Location: Lynnwood, WA USA
Posts: 1,669
Thanks: 0
Thanked 0 Times in 0 Posts
Default Re: Proportioning valve/Roll Control

Hi Tom,
I definitely would not disable the rear brakes by adjusting the proportioning valve. A line lock (roll control) is the way to go with a stick car to help with burnouts and staging.

Before adjusting the proportioning valve, I would first make sure all your individual brakes are adjusted properly. Lift each wheel off the ground to check. Your front disks should offer a little drag as you spin each wheel, and you can adjust the rears until you feel drag then back them off a little (If you have limited slip you need to get both rear wheels up at the same time).

If you have a standard brake set-up (factory size brakes front and rear) you might want to use the standard factory proportioning valve that will not require any adjustment. If you have beefed up your brakes and need an adjustable valve, call the manufacturer and ask them what setting they recommend to start with.

Then I would find a safe, open, low traffic area for testing (maybe a big parking lot after hours?). Speed up to around 20 MPH and stop real hard, to the point of lockup. If the fronts or rears are locking up first, then make an adjustment to the proportioning valve. If one wheel locks up, check out the brake adjustment on that wheel instead. If they seem to lock up all at once, then you are done.
__________________
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT. The time now is 04:29 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.

O Garage vBulletin Plugins by Drive Thru Online, Inc.