Any idea WHAT this block is?

[Chevy454]

We found a block, but we can't find the number listed anywhere: #3952318

It's supposed to be an aluminum block.

[Rowdy Rat]

I show 3952318 as the original PART NUMBER for a big block Chevy aluminum cylinder case CASTING NUMBER 3946052... Your run of the mill ZL-1 block.

Regards,

Stan Falenski

[Edited by Rowdy Rat (10-30-2001 at 04:03 PM).]

[Chevy454]

Hmmm...guess I could have looked THAT up! It's supposed to be a "Can Am" block. What #s did they use?

[sYc]

Stan; Thanks for the quick reply. Now, for a couple of more questions. Could the block be a Yenko block? std. or tall deck? would the part number --2318 be on the block? thanks; Tom

[Rowdy Rat]

<BLOCKQUOTE><font size="1" face="">quote:</font><HR>It's supposed to be a "Can Am" block. What #s did they use?<HR></BLOCKQUOTE>

I show two additional part numbers for service replacement aluminum blocks. The first, 3992038, was made from the same 356 T6 alloy as the "regular" ZL-1. It was equipped with dry cylinder liners (again, like the ZL-1), but with a bore of 4.440" instead of the typical 4.250" bore of the standard ZL-1. I show this block as available beginning in 1969.

The second, 3965755, was a linerless block made from a high silcon Reynolds 390 alloy (pretty sure that this is the same material that the Cosworth Vega engines were cast from... hopefully, the big blocks received better quality control ) with 4.440" bores. I show this block as being available in 1972.

I'm sorry that I can't provide casting numbers for either of these blocks, but I'll keep digging and see what I can turn up.

<BLOCKQUOTE><font size="1" face="">quote:</font><HR>Could the block be a Yenko block? std. or tall deck? would the part number --2318 be on the block? <HR></BLOCKQUOTE>

Tom,

My initial thoughts are that if it has a Chevrolet part number, it is unlikely a Yenko block. I have no hard evidence to support this, so if your research uncovers evidence that it is, I'd sure like to hear about it. I do know that Yenko's tall deck block was very well received by the racers (the three blocks mentioned above are all standard deck height blocks to the best of my knowledge) and I would imagine it to be quite valuable should you uncover one.

There was some sort of tie in between Don Yenko, GM, Alcoa, and Winters that resulted in Don getting these blocks cast in the first place, but I'm not sure what part each played in this business relationship. I'd be curious as to what details others can provide.

Regards,

Stan

[Edited by Rowdy Rat (10-31-2001 at 01:00 AM).]

[JoeC]

Stan, My understanding is that the ZL1 and the CanAm block are different castings. The ZL1 is similar to the iron BB design and has "wet" liners meaning coolant passes in between the adjoining cylinders. The CanAm block has a 4.440 in. dia. bore with Siamese cylinder design (like the 400 SB) where coolant does not pass between adjoining cylinders (dry liners). The other CanAm block has no liners and used a special coating on the pistons to control wear.