Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars. |
|
|||||||
| Register | Album Gallery | Thread Gallery | FAQ | Community | Calendar | Become a Paid Member | Today's Posts | Search |
|
|
|
Thread Tools | Display Modes |
|
#1
12-17-2003, 03:17 PM
|
|||
|
|||
Yenko deuce rear sway bar.
Can anyone provide me with the width from side to side of the rear swaybar for a deuce along with how long are the vertical bars? I picked up a complete setup and I think the bar is correct but not sure about the verticals.. [img]/ubbthreads/images/graemlins/dunno.gif[/img]
|
|
#2
12-17-2003, 03:55 PM
|
||||
|
||||
|
Re: Yenko deuce rear sway bar.
I can measure mine tonight.
The 'hangers' should bolt below the bar, not in front of it, when properly mounted to the special lower leaf spring brackets.
__________________
Marlin 70 Yenko Nova-350/360, 4speed M21, 4.10 Posi (Daddy's Ride) 69 SS Nova-396/375hp, 4speed M20, 3.55 Posi (Benjamin's Ride) 67 RS Camaro-327/250hp, 2speed Glide, & 3.08 Open (Danny's Ride)
|
|
#5
12-23-2003, 08:01 PM
|
|||
|
|||
|
Re: Yenko deuce rear sway bar.
Bill,
The sway bar set up you saw in my garage measures 38 1/4" wide on bar.The verticals measure 11 1/2" center to center on bushings.Over all 13" on verticals.This unit is from a 74 nova with f41.The verticals have the lower bolt connection facing the wrong way for a 70.But should be the same dimensions.Earl
|
|
#6
12-24-2003, 02:32 AM
|
|||
|
|||
|
Re: Yenko deuce rear sway bar.
Bill, I will try to remember to measure mine. You most likley will have to remind me though. Send me a pm if I forget. Schonye
|
|
#7
12-24-2003, 09:48 PM
|
|||
|
|||
|
Re: Yenko deuce rear sway bar.
Measured the rear sway bar off my 70 L78 F41 car, 38 3/8" tip to tip, with a yellow paint mark on one end, hope this helps.SULLY
__________________
70 L78 Nova Fathom Blue,Bench, 4spd, F41, 3:55 71 Porsche 911 Targa
|
|
#9
01-01-2004, 02:42 AM
|
|||
|
|||
|
Re: Yenko deuce rear sway bar.
Bill, sorry I took so long. My droparms measure 14.5 in from where they attach up top, to the bottom. It measures 25in between the drops on the bar, and 33in to the inside where it goes throught the rubber mount. Mine has never been off. Schonye
|
|
#10
01-02-2004, 05:02 PM
|
||||
|
||||
|
Re: Yenko deuce rear sway bar.
The vertical bars have different c/l measurements, the Nova version is a little longer than the Camaro/later Nova version, but both will work.
__________________
Marlin 70 Yenko Nova-350/360, 4speed M21, 4.10 Posi (Daddy's Ride) 69 SS Nova-396/375hp, 4speed M20, 3.55 Posi (Benjamin's Ride) 67 RS Camaro-327/250hp, 2speed Glide, & 3.08 Open (Danny's Ride)
|
|
|
|
Linear Mode
