Hood Emblem Location

Unreal · #1 04-18-2001, 01:04 PM

Could someone offer me the "correct" location of the 427 badge on the cowl hood. I'm sure it varies, since they were installled somewhat haphazzardly, but I'd like to get close. A measurement from the short part of the rear of the scoop to either the trailing edge of the badge, or the first hole would be very helpful.
Thanks for your help.
Gary

Yenkofan · #2 04-18-2001, 02:30 PM

Mine measure 21 1/8 inches from the indented part of the cowl hood to the edge of the emblem. Good luck.
Gary

Unreal · #3 04-23-2001, 02:04 PM

Thanks alot.

I assume the emblem is in the vertical middle of the raised portion. Is that correct.
Thanks again.
Gary

Yenkofan · #4 04-24-2001, 04:18 PM

Mine are not centered vertically.
They are "laying" on the curved portion of the hood where the hood and raised cowl meet. This leaves approx. 1/2 inch space at the top of the cowl portion.
Gary

Unreal · #5 04-25-2001, 12:22 PM

Gary,
Thanks for the help.
Gary

**YENKO DEUCE REGISTRY** · #6 04-25-2001, 08:31 PM

Hope this helps a little, original hood with holes.
M

[Edited by YENKO DEUCE REGISTRY (04-25-2001 at 03:31 PM).]

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars.