![]() Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars. |
|
Register | Album Gallery | Thread Gallery | FAQ | Community | Calendar | Become a Paid Member | Today's Posts | Search |
![]() |
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
Does anyone make a stamped lower hose fro a BB car that actually fits??
Bought a stamped hose kit from Ground up and, lower is not even close to fitting I assume it should flare out at water pump inlet.,but its the same size on both ends?? Thanks
__________________
Custom Cam /Engine Dyno and Spintron Operator at Brian Tooley Racing R@D 84 Mustang/Hertz Rent-a-Car 438CI 5.58@123 8.80@147 On Radials ALL MOTOR Powered by my 13 year olds engine program 68 NOVA 396-375 HP F.A.S.T. Project |
#2
|
|||
|
|||
![]()
Am I the only one running a lower hose on their Nova ??? [img]<<GRAEMLIN_URL>>/grin.gif[/img]
__________________
Custom Cam /Engine Dyno and Spintron Operator at Brian Tooley Racing R@D 84 Mustang/Hertz Rent-a-Car 438CI 5.58@123 8.80@147 On Radials ALL MOTOR Powered by my 13 year olds engine program 68 NOVA 396-375 HP F.A.S.T. Project |
#3
|
|||
|
|||
![]()
I measured an original lower rad hose, it's not flared, the inside diameter measures 1 3/4 inches at both ends. Hope this helps.
|
![]() |
|
|