|
Register | Album Gallery | Thread Gallery | FAQ | Community | Calendar | Become a Paid Member | Today's Posts | Search |
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
Original factory U-joints, can you re-use?
So I have a fellow member looking for 69 Camaro Factory U-joints, of which I think I have 5 or 6.
The question is: What does it take to refurbish these and use these? Is it just clean, inspect roller bearings and surfaces for wear, then grease?
__________________
69 SS 350 convertible (in peices) 69 327 convertible (driver) |
The Following User Says Thank You to KevinW For This Useful Post: | ||
mhm1966 (12-01-2022) |
#2
|
||||
|
||||
I have re-used Clean, unworn, complete u-joints many times by keeping the caps all on their original shafts. The bare cross shafts with rust are not a candidate in my book. ANY hint of brinelling by the needles is a no go as well. They need to look and feel like new.
__________________
Mitch 1970 Chevelle SS 1966 Chevelle SS 1967 Camaro ss/rs 1938 Business coupe, street rod 2000 FXSTS, original owner, 13k miles |
The Following User Says Thank You to Too Many Projects For This Useful Post: | ||
dustinm (11-30-2022) |
#3
|
||||
|
||||
Not to high jack the thread but if you have an original u joint I would be interested in it.
Email me at: [email protected] |
|
|