Gramma's Car: the new project!

[njsteve]

And another part on order. The original dash speaker stopped working recently for the factory AM/FM mono radio. I pulled out the A/C ducting and accessed the wiring. I was able to confirm the bad speaker by using a jumper wire to an old Kraco 6x10 speaker.

I ordered a replacement speaker from Electro-Tech. I have bought their 4x10 replacement speaker before and it worked very well and fit perfectly into the factory under dash bracket. They are the correct 8-ohm rating that will work with the factory radios, versus all the 4-ohm replacement versions out there that will fry your original radio eventually.

With shipping it was around $59

http://www.turnswitch.com/speakers.htm

I spent a couple hours today installing it. You have to drop the steering column and remove the gauge pod to access the speaker and get to the screw that holds the speaker bracket in place. Removing the A/C plastic ductwork really helps also. At the same time I replaced the non-existent foam seal on the main A/C duct. The original had turned to dust decades ago, leaving a 3/4" gap between the heater box and the main duct. Got everything buttoned up and now the front and back speakers sound just like new (like 1970's new, that is)