Restoration parts questions CAMARO

[Denis]

I'm pretty sure the original 67 front disc backing plates were bright cadmium plated and the rear drum disc backing plates were black, same gloss and paint as the rear axle assembly.

I bought a set of reproduction 67 front backing plates and they looked pretty good, had part numbers and everything. I ended up replating my originals and resold the repros before comparing up close, but they looked good even if the plating seemed more link zinc (brighter) than cad (duller).

[FESTIVAL78]

Galvanizing is common on Camaros but nobody offers to do it or even recognizes that thats what it is..I know that the taillamp back, fuel neck and 6 or so convertible top parts as well as all window regulators and tracks are galvanized..I bet the backing plates could have been too..great point..I think your right about different style jacks as well..I would want to use new repro items only if they had the correct finishes on them and fit but I doubt they are galvanized etc..that's why I'm asking for hands on reporting..thanks so far

[Nova Research Project]

What was the original finish on the front drum backing plates?

Thanks,
Greg

[FESTIVAL78]

My regulators and tracks are in fine physical condition and the galvy is mint..I was just thinking of getting repro ones so I did not have to waste time riveting new rollers on. I did some looking and found that all the places that hot dip (850 degrees) galvanize are very big companies not interested or set up to help out the little guy..I did find a guy in Everette Mass that said he'd do it for me...he said the Land Rover restorers have been using him for years??? Anyway, I'll get back to all of you when i have it done and post some comparison photos..hopefully my stuff wont come back looking like a freeway guardrail!..Anyone with the repro jack assembly feel free to speak up..and THANKS

[copojoe]

Does anyone out there in the camaro world have a extra set of window roofrails that they might want to sell? I hope i discribed them correctly, it's the stainless steel channels on the lt and rt side of the car for the window weather strip to set into. Thanks!
If so, you could e-mail me at [email protected]