Hood Emblem Location

[Unreal]

Could someone offer me the "correct" location of the 427 badge on the cowl hood. I'm sure it varies, since they were installled somewhat haphazzardly, but I'd like to get close. A measurement from the short part of the rear of the scoop to either the trailing edge of the badge, or the first hole would be very helpful.
Thanks for your help.
Gary

[Yenkofan]

Mine measure 21 1/8 inches from the indented part of the cowl hood to the edge of the emblem. Good luck.
Gary

[Unreal]

Thanks alot.

I assume the emblem is in the vertical middle of the raised portion. Is that correct.
Thanks again.
Gary

[Yenkofan]

Mine are not centered vertically.
They are "laying" on the curved portion of the hood where the hood and raised cowl meet. This leaves approx. 1/2 inch space at the top of the cowl portion.
Gary

[Unreal]

Gary,
Thanks for the help.
Gary

[YENKO DEUCE REGISTRY]

Hope this helps a little, original hood with holes.
M





[Edited by YENKO DEUCE REGISTRY (04-25-2001 at 03:31 PM).]

[YENKO DEUCE REGISTRY]

[Unreal]

I'm not very smart....can someone make this a hot link, so I can get to it? I tried to go there, but it kept saying I was making an error in the address.
Thanks,
Gary

[Chevy454]

http://albums.photopoint.com/j/View?...nce=0&res=high

[Edited by Chevy454 (04-27-2001 at 08:40 AM).]

[Wacky174]

Boy that picture looks familiar !!