|
|
|
|||||||
| Register | Album Gallery | Thread Gallery | FAQ | Community | Calendar | Become a Paid Member | Today's Posts | Search |
|
|
|
Thread Tools | Display Modes |
|
#1
11-03-2023, 07:53 AM
|
|||
|
|||
Removing/Replacing Delco Shock Bushings
Looking for advice, video on removing Rear Upper Cross
Bar and Bushing , then Reverse The Process
__________________
Chuck Sharin [email protected] Auburn,WA (30 miles South of Seattle) 70 Camaro R/S Z-28, L-78, R/S SS 69 Camaro COPO "recreation" 
|
|
#2
11-03-2023, 01:20 PM
|
||||
|
||||
|
Getting the old one out shouldn't be an issue. I would use a utility knife and cut the expanded heads off and start drilling holes in the bushing until it is pliable enough to press out. Installing the bushing alone should be fairly easy and then lubricate the bar with a strong solution of dawn soap and press in. The assembly would be after any necessary rust removal and coatings applied to the metal parts.
__________________
Mitch 1970 Chevelle SS 1966 Chevelle SS 1967 Camaro ss/rs 1938 Business coupe, street rod 2000 FXSTS, original owner, 13k miles
|
| The Following 3 Users Say Thank You to Too Many Projects For This Useful Post: | ||
|
#3
11-03-2023, 03:31 PM
|
||||
|
||||
|
If you are going to restore your shocks back to original Chuck, make sure you paint the shocks after the bushings are installed.
__________________
Rick Nelson Musclecar Restoration and Design, Inc www.musclecarrestorationanddesign.com https://www.youtube.com/watch?v=62r-6vgk2_8 specializing in (only real) LS6 Chevelle restorations
|
| The Following User Says Thank You to SS427 For This Useful Post: | ||
enio45 (11-03-2023) | ||
|
|
|
Linear Mode
