|
Register | Album Gallery | Thread Gallery | FAQ | Community | Calendar | Become a Paid Member | Today's Posts | Search |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
69 Camaro smog pump finish
Anyone have any success trying to replicate the finish on the housing? If so details please.
Thanks, Doc. |
#2
|
|||
|
|||
C'mon guys,nobody has tried this?
|
#3
|
|||
|
|||
I would think it is exactly the same procedure as an alternator case. They are both cast aluminum
__________________
Don't believe everything you read on the internet ... Ben Franklin |
#4
|
|||
|
|||
I cleaned up my Nova pump with a grey (fine) scotch brite pad and lacquer thinner. Then went over it with 0000 steel wool.
|
#5
|
||||
|
||||
Send it to Bill Hodel
__________________
Follow me on Instagram: https://www.instagram.com/mbcgarage/ |
#6
|
|||
|
|||
And pay big bucks i can do it cheaper
|
#7
|
|||
|
|||
pm sent
|
#8
|
|||
|
|||
I know it is not what some like but here is what I can make a pump look like.
|
#9
|
||||
|
||||
If I could ask, how did you get the front bearing out without trashing the case, and how are you going to retain the new front bearing ?
Thanks Mike |
#10
|
|||
|
|||
I just press out the shaft with the bearing and then used green loctite sleeve retainer on the bore and new bearing.
|
The Following 3 Users Say Thank You to McCune For This Useful Post: | ||
|
|