|
Register | Album Gallery | Thread Gallery | FAQ | Community | Calendar | Become a Paid Member | Today's Posts | Search |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
67/68 and 69 Big Block Camaro Drive Shaft Length
67 & 68 396 camaro frame mounts move the motor about 1 " forward on the sub frame "K" member as compared to a 69 396 car. I do recall that the drive shaft length of a 67/68 396, 4 spd car is longer than a 69 396, 4 spd car.
Does anyone know the drive shaft lengths? Thanks ! Last edited by 68 DANA; 11-26-2018 at 04:11 AM. |
#2
|
||||
|
||||
|
#3
|
|||
|
|||
Additional question on the length. I found the length of 49.56 inches for my application. my question is is that center to center of the u-joint or overall length of the shaft?
Thanks as always.
__________________
Chris Slawski 69 Nova 69 Malibu 69 Camaro RS 69 Camaro SS 396 |
#4
|
|||
|
|||
Chris -- I have always measured driveshaft length as center to center of the u-joints ... hope that helps ... Craig
__________________
You've never lived until you've almost died -- for those who fight for it, life has a flavor the protected will never know! |
The Following User Says Thank You to earntaz For This Useful Post: | ||
chris slawski (03-02-2020) |
#5
|
|||
|
|||
Defined in the top of the article:
Note: All lengths are measured from centerline to centerline of the universal joints.
__________________
Kurt S - CRG |
The Following User Says Thank You to Kurt S For This Useful Post: | ||
chris slawski (03-09-2020) |
|
|