|
|
|
|||||||
| Register | Album Gallery | Thread Gallery | FAQ | Community | Calendar | Become a Paid Member | Today's Posts | Search |
|
|
|
Thread Tools | Display Modes |
|
#1
04-25-2020, 06:42 PM
|
|||
|
|||
Reverse lockout rod
can anyone pls provide the measurement tip to tip for either a BB or SB lockout rod for 69 Camaro?
i have one gm rod but not sure of the application - no # stamped into this one. thanks alot... this is the long rod from trans reverse lever to the bell crank. thanks alot for the info
__________________
Eddie M MBTMF 68 COPO Camaro 9737 non-converted YENKO 69 YENKO SC Camaro, Hugger Orange - born with engine! 
|
|
#2
04-25-2020, 08:24 PM
|
||||
|
||||
|
Eddie I have an unstamped SB and it's just over 20 .6 inches . On the outer edge of that inserts into reverse lever on trans and bell crank. Not installed but that's what I believe the application.
__________________
Steve Shauger The Supercar Registry www.yenko.net Vintage Certification™ , Providing Recognition to Unrestored Muscle Cars. Website: www.vintagecertification.com
|
|
#3
04-27-2020, 05:52 PM
|
|||
|
|||
|
Steve, thank you for checking.....mine tip to tip is 20 3/8
I believe it came off my Z - been a while, how much longer would the BB rod be then. I know the shifter rods are not much different - around 1/2 to 5/8 if i recall. are you sure yours is SB then?
__________________
Eddie M MBTMF 68 COPO Camaro 9737 non-converted YENKO 69 YENKO SC Camaro, Hugger Orange - born with engine!
|
|
|
|
Linear Mode
