1970 LS6 El Camino on BaT

**tom406** · #1 08-20-2022, 03:06 AM

Love the colors and look. https://bringatrailer.com/listing/19...-el-camino-41/

**MosportGreen66** · #2 08-20-2022, 11:18 AM

Opinions on pad and trans stamp???

**BLACKLS5** · #3 08-20-2022, 01:11 PM

The engine is an obvious restamp IMO.

**MosportGreen66** · #4 08-20-2022, 01:37 PM

Quote:

Originally Posted by BLACKLS5

The engine is an obvious restamp IMO.

That was my insinuation also! Thanks

**scuncio** · #5 08-20-2022, 02:28 PM

Talked about this one earlier this year:

https://www.yenko.net/forum/showthre...=Camino&page=2

**dannystarr** · #6 08-20-2022, 03:11 PM

I am wondering why there is a ridge/rise in the pad area near the head. Is this some known casting normality? Or is it because it was cut down and they didn't get it set correctly?
Danny

**dannystarr** · #7 08-20-2022, 03:13 PM

Smaller clearer shot... D

**PeteLeathersac** · #8 08-20-2022, 03:46 PM

'

What's the McJerry Report mentioned in the previous thread note of engine stampings/originality?

136800K210296

~ Pete

.

**olredalert** · #9 08-20-2022, 09:19 PM

Quote:

Originally Posted by dannystarr

I am wondering why there is a ridge/rise in the pad area near the head. Is this some known casting normality? Or is it because it was cut down and they didn't get it set correctly?
Danny

----The broach marks look OK though. If so, I think your assumption of a step is really farfetched, though not, I guess, impossible. Is it possible that that the edge we see is the edge of the head gasket???....Bill S

**luzl78** · #10 08-20-2022, 09:54 PM

Quote:

Originally Posted by dannystarr

I am wondering why there is a ridge/rise in the pad area near the head. Is this some known casting normality? Or is it because it was cut down and they didn't get it set correctly?
Danny

Doesn’t it look like some shadow numbers,especially number 6 above the stamped vin?

The Following User Says Thank You to scuncio For This Useful Post:
PeteLeathersac (08-20-2022)