#1
|
|||
|
|||
AAR Cuda rake
Hi Guys, since I bought my Cuda I knew it sat too high in the front. I am just now getting around to adjusting the rake. I have it set at 25 9/16 on each side. Measured from the bottom of the fender lip to the ground. I think its getting close now. Some guys like to set them from 25 to 25.5. So I am close. Love to get your opinions.
Thanks Lawrence
__________________
65 Corvette Coupe L78 67 427/390 Vette Coupe unrestored 67 L-79 Vette roadster (Top Flight) 69 L71 Roadster Survivor 69 L46 Roadster Survivor (Sold) 69 Z/28 RS 69 Dodge Charger R/T 70 W30 442 Auto Air Survivor 2016 Z06 Coupe M7 70 AAR Cuda (Sold) 69 L78 Chevelle |
The Following 5 Users Say Thank You to sixt9rsx33 For This Useful Post: | ||
cruiserofland (06-05-2022), markinnaples (06-13-2022), napa68 (06-05-2022), Xplantdad (06-06-2022), YenkoYS-199Stinger (06-06-2022) |
#2
|
|||
|
|||
That is one feature I always liked on the Mopars. So easy to adjust ride height.
__________________
Don't believe everything you read on the internet ... Ben Franklin |
#3
|
|||
|
|||
That's nice AAR! B5 is one of my favorite colors! I'll have to put a tape measure on my 'Cuda but I think mine sits on the lower end of that spectrum. I definitely have some tire tucked into the fender. I think it would ride better if the car was higher like yours but the stance says I want to stay here!
__________________
Camaro, 'Cuda, Super Bee, Duster, Blazer and some trucks |
The Following User Says Thank You to Andy For This Useful Post: | ||
69M22Z (06-15-2022) |
|
|