Joe's (X66 714) 1969 SS 396 Camaro "The life & times of X66 714"

[olredalert]

Originally Posted by Jonesy

Thats exactly how I did my car. (Just like Joe). I had a rolling subframe with complete engine and trans and rolled it to the body. It was easier to install the fuel and brake lines this way too. I hooked all that up and then placed wheel wells and fenders. I thought it went very smooth.

----I did 3 69 Z's this way. It was easy for two people, and not much harder for one which is how I did all three.....Bill S

[Calix Lee]

It seems like this project has been keeping you busy for the past few months. I guess this build is going well so far and honestly, I can't wait to see how it will turn out.

[X66 714]

I haven't been to my page in a while but I did finish up all the little stuff on the rear of the car. I have another headliner that I purchased from SMS. So far I like it a lot. That will be starting tomorrow.

I hope everybody had a wonderful New Year

Joe

[duskblue]

Looking good Joe ,cool car

[X66 714]

I thought I would post a picture of how tight these cars get with a/c & smog. Still more to add. The fenders & wells will make it even tighter...Joe