|
|
|
|||||||
| Register | Album Gallery | Thread Gallery | FAQ | Community | Calendar | Become a Paid Member | Today's Posts | Search |
|
|
|
Thread Tools | Display Modes |
|
#11
12-05-2014, 01:09 PM
|
|||
|
|||
Re: Big Block Exhaust Manifold gaskets
no gaskets, I have used the copper before and high temp red as well. Gaskets were in trucks.
__________________
Micky Hale Hale Performance Consultants Engine Parts Sales & Service 
|
|
#12
12-05-2014, 01:16 PM
|
|||
|
|||
|
Re: Big Block Exhaust Manifold gaskets
If you're a 100% certain the head and manifold surfaces are flat, no gasket will be required. If there is a question if this is true, then what Al said is what you need to do ... use the sealer.
TAZ
__________________
You've never lived until you've almost died -- for those who fight for it, life has a flavor the protected will never know!
|
|
#13
12-05-2014, 03:38 PM
|
|||
|
|||
|
Re: Big Block Exhaust Manifold gaskets
If you have manifolds that are not warped I just use the white paste. Any parts store 3 dollars and a pinch does the trick for each side.
|
|
#14
12-05-2014, 06:46 PM
|
||||
|
||||
|
Re: Big Block Exhaust Manifold gaskets
I've always used Ultra Copper on my aluminum headed
drag race engines with no problems or leaks that could be seen. Although the headers are not cast iron nor the heads it certainly is a much easier assembly. Dicky [img]<<GRAEMLIN_URL>>/flag.gif[/img]
__________________
Dicky 
|
|
|
|
Linear Mode
