"Baby Pictures" of your supercar.... - Page 13

Plowman · #**121** 01-08-2017, 07:20 AM

x2 Nice.

markinnaples · #**122** 01-08-2017, 09:28 PM

That Chevelle is too cool.

**X66 714** · #**123** 01-10-2017, 09:01 PM

My 1968 Z/28 ready for street racing early 80s. Still had original paint at that time. Still have it. Restored to original now..Joe

novadude · #**124** 01-10-2017, 09:15 PM

That Z/28 is cool! What powertrain were you running in the era of those photos?

**X66 714** · #**125** 01-10-2017, 09:21 PM

I think that's when I had the 302 race motor. It was 12.5 with the 1st design service cam. Didn't like to idle real well with mufflers. Car was ordered new with 4.56 gears. That's still the same...Joe

**SS427** · #**126** 01-10-2017, 09:49 PM

Nice!

**X66 714** · #**127** 01-10-2017, 11:23 PM

Thank you...Joe

**Bob_D** · #**128** 12-25-2017, 07:00 PM

Three pictures of my 1973 Formula some time in late 1973. This is the car we factory ordered for my girlfriend (now my wife of 42 years), hence only the 350 was spec'd. Less than a year later she got a company car and sold the Formula to me. It replaced my decrepit 68 Cutlass.

**Bob_D** · #**129** 12-25-2017, 07:17 PM

These three pictures are of my high school friend's 1970 Corvette. He was too late to factory order a new 69 L-88 Corvette. So Brigance Chevrolet had him order a 1970 with the LT-1 motor. Joe Seputis (Vetteran Automotive) worked for Brigance at the time. Upon arrival from the factory, they dropped in what was the latest version of L-88. Called a "ZLX". Joey C. (my friend) drove out of the dealer with a brand new 1970 ZLX dealer built Vette. It had a 4:88 rear end I believe. Not sure which Muncie it had. I think Joey C. still owns this car. He went on to have Seputis built the motor even wilder. General Kinetics cam, tunnel ram manifold, etc. He eventually turned it into a full Custom with a lot of body mods., for the 1970's show circuit.

Postsedan · #**130** 12-25-2017, 10:03 PM

Very cool Bob.....if we only would have kept them all

Dan

The Following User Says Thank You to X66 714 For This Useful Post:
Stihl (10-18-2023)

The Following User Says Thank You to novadude For This Useful Post:
L79Chevelle (12-31-2022)

The Following 3 Users Say Thank You to Bob_D For This Useful Post:
PeteLeathersac (12-31-2022), Stihl (10-18-2023), turbo69bird (09-24-2023)

The Following 2 Users Say Thank You to Bob_D For This Useful Post:
PeteLeathersac (12-31-2022), turbo69bird (09-24-2023)

The Following User Says Thank You to Postsedan For This Useful Post:
rhduntov (12-27-2017)