#1
|
|||
|
|||
Mopar Question
I posted this in the Technical & Restoration section but didn't get any responses.
A friend that owns a repair shop has a customer's 1973 Challenger with a 340 in it. The driver's side of the engine is almost 1 1/2" lower than the driver's side. The customer had the engine rebuilt recently. My friend is not sure if the correct motor mounts were used or if there is some other issue. Any suggestions would be greatly appreciated. James
__________________
1968 Beaumont SD396 |
#2
|
|||
|
|||
Re: Mopar Question
Being as how it is a 73' you may want to replace the mounts -- get a OEM spec height mounts and go from there to see if motor sits level in the chassis. TAZ
__________________
You've never lived until you've almost died -- for those who fight for it, life has a flavor the protected will never know! |
|
|