Rebuild fuel pump - Page 2

BCreekDave · #11 06-03-2021, 03:41 PM

Does Fred use brand new upper castings and re-stamp the numbers? I never see any remnants of bolts being used previously.

**R68GTO** · #12 06-03-2021, 04:24 PM

Quote:

Originally Posted by BCreekDave

Does Fred use brand new upper castings and re-stamp the numbers? I never see any remnants of bolts being used previously.

Fred re-uses what you supply. Not following the remnants of bolts reference?

cook_dw · #13 06-03-2021, 04:55 PM

You can see on the bolt hole closed to the outboard side of the motor that it’s been installed previously.

BCreekDave · #14 06-03-2021, 07:10 PM

Quote:

Originally Posted by cook_dw

You can see on the bolt hole closed to the outboard side of the motor that it’s been installed previously.

I see it now. Had to blow it up a bit. Most holes are usually more chewed up than that.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

The Following User Says Thank You to R68GTO For This Useful Post:
X66 714 (06-03-2021)

The Following User Says Thank You to cook_dw For This Useful Post:
R68GTO (06-04-2021)