I finished polishing up windshield stainless moldings today after sanding them over the past few weeks -using the sisal, then spiral wheel, then flappy wheel with the various compounds. Then I used blue painters tape to outline the entire painted border around the glass and marked the location of each clip with a sharpie. Then came the fingernail biting suspense of getting the moldings engaged without cracking the glass. I used a small rubber mallet and gently but firmly whapped the marked locations. It worked without issue.
I then tried to install the wiper blades but it seems I must have installed the wiper articulating arms backwards because it tried to go toward the cowl when starting. Luckily I didn't install the arms before I tested them. That's the next project.
Last edited by njsteve; 12-10-2020 at 11:17 PM.
|
12-10-2020, 11:04 PM
Threaded Mode