|
|
|
#2
10-29-2023, 02:21 PM
|
||||
|
||||
I believe it's GM dexron automatic transmission fluid.
|
|
#3
10-29-2023, 02:34 PM
|
||||
|
||||
|
Found this pic and it does look like it's auto trans fluid. hard to read if it specifies Dexron... maybe someone can enlarge it.
__________________
Mitch 1970 Chevelle SS 1966 Chevelle SS 1967 Camaro ss/rs 1938 Business coupe, street rod 2000 FXSTS, original owner, 13k miles
|
|
#4
10-29-2023, 02:37 PM
|
||||
|
||||
|
As a side note, these were originally built only for Ford applications, so it may want FOMOCO fluid ? The 300 universal model came along well after the initial introduction, so I would believe the lube requirements would be the same as the earlier Ford models...
__________________
Mitch 1970 Chevelle SS 1966 Chevelle SS 1967 Camaro ss/rs 1938 Business coupe, street rod 2000 FXSTS, original owner, 13k miles
|
| The Following User Says Thank You to Too Many Projects For This Useful Post: | ||
chevyandpontiac (10-30-2023) | ||
|
#5
10-29-2023, 03:28 PM
|
|||
|
|||
|
The 300 hone o drive instructions i have identify one quart of ATF automatic transmission fluid and refers to instruction 11.
instruction 11 reads; "Fill the HONE-O-DRIVE with 1-3/4 pints of Automatic Transmission Fluid. Never allow oil level to be more than 1/8" below oil fill hole. Check level at each engine oil change, and watch for possible seal damage at both ends." Hope this helps take care Andy
__________________
Andy Team Chevelle #3135 ACES #08305 1969 Chevelle Trim Tag Research (On-going)
|
| The Following 2 Users Say Thank You to SS69chevelle For This Useful Post: | ||
chevyandpontiac (10-30-2023), COPO (10-29-2023) | ||
|
#6
10-29-2023, 05:39 PM
|
|||
|
|||
|
Yes, it is ATF. I'm not sure it matters if it is Dextron or Motorcraft since there are no clutches to be concerned with.
Jason
|
| The Following 2 Users Say Thank You to SuperNovaSS For This Useful Post: | ||
chevyandpontiac (10-30-2023), L_e_e (10-29-2023) | ||
 |
|
|
Linear Mode
