#1
|
|||
|
|||
MUNCIE FILL PLUG
the fill plug in my 69 Muncie 4 speed is frozen in the case I cant get it to come loose any suggestions on how to get it out with out damaging the case
|
#2
|
||||
|
||||
Re: MUNCIE FILL PLUG
Heat it up and melt wax into the threads.
Kurt |
#3
|
|||
|
|||
Re: MUNCIE FILL PLUG
The wax trick is a good one. Is the trans in the car or out? It is assembled or apart for rebuild? I have more experience with aluminum intake fittings which are a pain due to corrosion, etc. A trans plug should be similar. If intake plugs/fittings are tough I drill and cut them out.
Jason |
#4
|
|||
|
|||
Re: MUNCIE FILL PLUG
THE TRANS IS IN A RUNNING CAR IT LOOKS LIKE SOMEONE HAS TRYED SEVERAL TIMES TO REMOVE THE SQUARE HEAD IS WELL ROUNED OFF DO YOU HEAT THE PLUG OR THE CASE ALSO WHAT TYPE OF WAX DO YOU USE
|
#5
|
||||
|
||||
Re: MUNCIE FILL PLUG
you can buy a chunk of paraffin wax at the grocery store in the canning supplies section or at any craft store.
__________________
1969 Z11 L48 4 Speed |
#6
|
|||
|
|||
Re: MUNCIE FILL PLUG
Use a large pipe wrench for leverage and it will come out. I had the same problem last week with a Muncie trans.
__________________
67 Z/28 Butternut Yellow 69 Z/28 Rally Green 69 Z11 Pace Car (2) 69 RS/Z28 Lemans Blue / Olympic Gold 2010 2SS RS Aqua Blue 68 Z/28 Lemans Blue C7 Corvette 68 SS Lemans Blue |
#7
|
|||
|
|||
Re: MUNCIE FILL PLUG
If the square nut is rounded and you can't get a pipe wrench on it. Weld a rod or small piece of flat stock steel onto the filler head. Use this for leverage to remove the filler plug. The little heat from the weld will help loosen it. You will need to buy a new drain plug anyway.
__________________
Looking for the next project. |
#8
|
|||
|
|||
Re: MUNCIE FILL PLUG
buy a large nut that the plug head fits in, mig it in center just take your time get a good weld, wait a minute, and 2 things happen, you get real heat on it and then you can get a boxed end on it, it will back right out. Ive done it on the floor, but a rack makes it less miserable..and it works...
__________________
Mark |
#9
|
|||
|
|||
Re: MUNCIE FILL PLUG
Usually the Hex head Is rounded off around the Bottom and not the top. There are 2 kinds of sockets that can be used in that case..
Turbo Sockets , and 8 pt sockets. They All are best used when the trans is warm after a drive. Rust grows on the steel or cast plug in the aluminum case thru condensation and expands stronger than lock -tite .. Drilling both plugs are the best option in the end If none of the others do it for you... Never tried the Wax route..
__________________
Tubbed 69 camaro |
#10
|
|||
|
|||
Re: MUNCIE FILL PLUG
I'ved used the wax on steam heater fittings that are a hundred years old with good results. The best wax that I've found for this is a "plumbers candle".
__________________
Tony 55 Nomad Gasser 70 SS 427 Nova 34 Ford Sedan..Hemi powered Michigan/ Florida |
|
|