SBC 461 Heads

[napa68]

I am in need of a set of 461 SBC heads dated late August to early September of 62. Non ported straight up castings preferred.

Thanks,

Tim

(262) 844-5218
[email protected]

[VintageMusclecar]

What valve sizes?

Screw in or pressed studs?

Bare castings or ready to install?

[Fast67VelleN2O]

All 461X heads were pressed in studs and 1.94 valves. In 1963, 340 and 360 fuelie versions got swirl polished valves but the valve sizes still stayed 1.94.

[napa68]

<div class="ubbcode-block"><div class="ubbcode-header">Originally Posted By: Fast67VelleN2O</div><div class="ubbcode-body">All 461X heads were pressed in studs and 1.94 valves. In 1963, 340 and 360 fuelie versions got swirl polished valves but the valve sizes still stayed 1.94. </div></div>

Yea, what he said! As far as condition, I will consider bare castings, good cores, and finished heads. Just looking for good heads that have not been messed up with the date range I detailed in my post. The heads are the last of what I need to button up the engine for my fuelie.

Thanks,

Tim

[VintageMusclecar]

Sorry for all the ?'s, I might be able to help, just trying to cover the bases before I make any calls.

[Fast67VelleN2O]

I have a mint untouched pair of X heads (bare) but they are too early for you. Good luck on the search. They are getting hard to find.

[VintageMusclecar]

All I could come up with was late September dates.

Sorry I couldn't help.

[napa68]

Thanks everyone. I am still looking. A fellow on Corvette Forum says he may have a set of early September heads. Until then.................

Thanks,

Tim

[napa68]

Still looking................

[RPOLS3]

Didn't Joe Smith have a set at MCACN - maybe the dates were too late?

Jake