Crane 3727140 Blueprint Cam and Lifters, Almost NOS
Been holding onto this since the late 1990s. This is a Crane blueprint 140 cam kit that I bought from a friend who assembled it into his 302, ran the engine on the dyno and was unhappy with the power, and had the builder swap the cam and lifters for a 1970 LT-1 cam (which I believe is the part number shown on the cam box). This set has a couple hours of run time and looks essentially new. You wouldn’t even know it had been run but for some shiny areas on a few of the lobes and on the sides of the lifters. I know “used” camshafts have a stigma but I would not be afraid to run this; lifters are still in order in their original box. Produced in the heyday of Crane Cams back when metallurgy wasn’t an issue. I’d like $250 for the set and would listen to a good offer.
|
02-23-2025, 03:09 PM
Linear Mode
