Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars. |
|
|
|
#1
02-27-2005, 05:07 PM
|
|||
|
|||
Cast iron pulleys
What type of engines were these used on typically. Bigblocks, in Corvettes or what ?
The left one is 6 and 3/8", and the right one is 5 and 11/16" Anders
__________________
Anders Stålklint. After selling my COPO 9561 I´m now a "postman" with the main project being a 1966 327 2 dr sedan Chevy II. 
|
|
#2
02-27-2005, 09:22 PM
|
|||
|
|||
|
Re: Cast iron pulleys
I have seen power steering pulleys, but not ones that big. Any part numbers?
__________________
67 Z28, 67 RS/SS 396 Canadian, 73 Camaro Z28/LT Carolina Blue
|
|
#3
02-27-2005, 11:01 PM
|
|||
|
|||
|
Re: Cast iron pulleys
I thought these were regular Chevrolet stuff, but I guess not. I know these two came off Opel Chevrolet small-block engines. The big one is from a -66 283 and the small one is from a -74 327. I once had a -72 Opel 327, and it had one like the smaller one to.
There are some numbers cast into the smaller one, but it isn´t readable. I think I can see the Opel logo though. I know the logo is on the powersteering pump-pulley that is made from sheetmetal. There aren´t that many Opel Admiral and Diplomat autobahn racers around, so I guess I´ll put them back on the shelf, unless they were used on Chevies aswell.  Anders
__________________
Anders Stålklint. After selling my COPO 9561 I´m now a "postman" with the main project being a 1966 327 2 dr sedan Chevy II.
|
 |
|
|
Hybrid Mode
