Dumb Question...

[Seattle Sam]

Where can I get the correct hose adapters to screw into the water pump and intake manifold for the heater hoses? Mine are a little skanky and I'd like to replace them with new...

Thanks!

[Postsedan]

Sam,

Try.... Ground Up
http://www.ss396.com/

Dan.

[m22mike]

I like PSST stainless fittings, not correct, but correct looking and they do not look like crap a week after installing new ones, that are zinc plated JUNK. I have had some old ones cad plated, and they are ok.
Here is a link http://performancesst.com/customer/p...=13&page=1
Ricks and Summit carry them too

[Seattle Sam]

Thanks Dan and Mike!

[camarojoe]

Good luck getting the old ones out if they've been in there awhile... sometimes they can be really stubborn, especially in an aluminum intake.

[Belair62]

Heat and a prayer for that intake unless some kind soul previously put teflon on the threads.

[Seattle Sam]

Lucky me, previous guy knew how to use teflon tape, I got them out tapping the big adjustable wrench with a BFH.